Wall mounted tap is one of the classical accessory used in kitchen, bath room and etc… A staggering choice of top quality wall mounted bathroom accessories available in online shopping. These taps have great look at our home. Bib tap-stands can be supplied for some ranges, which will convert the bib taps into long-reach high necked pillar taps. Useful for installation with wide-rimmed laundry sinks.
Wall mounted taps give your bathroom a truly polished look. Mounting taps directly into the wall removes ugly pipe work from sight and can create a sense of extra space. We have modern, traditional and minimalist wall mounted bathroom taps to suit any bathroom.
Before fitting the taps we should follow some precaution steps as follows
Fit the tails of the tap first by screwing a chrome flange onto the large threaded part of the tail. Put a large flat washer into one of the nuts at the back of the wall mounted tap and screw the nut onto the tail finger tight. Repeat for the other tail. Adjust the tails until they are positioned correctly for the inch threads to go through the hole in the sink. Fully tighten the nuts and screw the chrome flanges fully forward to the nuts.
After checking all connections then ready to fit the new one by carefully, which gives your bath room is more bright and wonderful! After checking all new connections, turn on the mains stop cock. Close all taps except the new wall mounted mixer and as the system starts to refill check for leaks. Once satisfied that there are no leaks the water heating should be switched back on.
Wall mounted taps give your bathroom a truly polished look. Mounting taps directly into the wall removes ugly pipe work from sight and can create a sense of extra space. We have modern, traditional and minimalist wall mounted bathroom taps to suit any bathroom.
Before fitting the taps we should follow some precaution steps as follows
Fit the tails of the tap first by screwing a chrome flange onto the large threaded part of the tail. Put a large flat washer into one of the nuts at the back of the wall mounted tap and screw the nut onto the tail finger tight. Repeat for the other tail. Adjust the tails until they are positioned correctly for the inch threads to go through the hole in the sink. Fully tighten the nuts and screw the chrome flanges fully forward to the nuts.
After checking all connections then ready to fit the new one by carefully, which gives your bath room is more bright and wonderful! After checking all new connections, turn on the mains stop cock. Close all taps except the new wall mounted mixer and as the system starts to refill check for leaks. Once satisfied that there are no leaks the water heating should be switched back on.
No comments:
Post a Comment